Part Number |
C9105AXI-S |
Software |
Catalyst 9105 AXI
Cisco Unified Wireless Network Software Release 8.10.MR3 or later
Cisco IOS® XE Software Release 17.3.1, or later
|
Supported wireless LAN controllers |
Cisco Catalyst 9800 Series Wireless Controllers
Cisco 3504, 5520, and 8540 Wireless Controllers and Cisco Virtual Wireless Controller
|
802.11n version 2.0 (and related) capabilities |
2x2 MIMO with two spatial streams
Maximal Ratio Combining (MRC)
802.11n and 802.11a/g
20- and 40-MHz channels
PHY data rates up to 444.4 Mbps (40 MHz with 5 GHz and 20 MHz with 2.4 GHz)
Packet aggregation: Aggregate MAC Protocol Data Unit (A-MPDU) (transmit and receive), Aggregate MAC Service Data Unit (A-MSDU) (transmit and receive)
802.11 Dynamic Frequency Selection (DFS)
Cyclic Shift Diversity (CSD) support
|
802.11ac |
2x2 downlink MU-MIMO with two spatial streams
MRC
802.11ac beamforming
20-, 40-, 80- MHz channels
PHY data rates up to 866.7 Mbps (80 MHz with 5GHz)
Packet aggregation: A-MPDU (transmit and receive), A-MSDU (transmit and receive)
802.11 DFS
CSD support
WPA3 support
|
802.11ax |
2x2 uplink/downlink MU-MIMO with two spatial streams
Uplink/downlink OFDMA
TWT
BSS coloring
MRC
802.11ax beamforming
20-, 40-, 80- channels
PHY data rates up to 1.488 Gbps (80 MHz with 5 GHz and 20 MHz with 2.4 GHz)
Packet aggregation: A-MPDU (transmit and receive), A-MSDU (transmit and receive)
802.11 DFS
CSD support
WPA3 support
|
Integrated antenna |
Catalyst 9105AXI
2.4 GHz: Peak gain 4 dBi, internal antenna, omnidirectional in azimuth
5 GHz: Peak gain 5 dBi, internal antenna, omnidirectional in azimuth
|
Interfaces |
Catalyst 9105AXI
1x 10/100/1000 Base-T (Ethernet) Uplink Interface
Management console port (RJ-45)
|
Indicators |
Status LED indicates boot loader status, association status, operating status, boot loader warnings, and boot loader errors
|
Dimensions (W x L x H) |
Access point (without mounting brackets): ◦ C9105AXI: 5.9 x 5.9 x 1.18 in. (150 x 150 x 30 mm)
|
Weight |
Cisco Catalyst 9105AXI
0.7 lb. (329.5g)
|
Input power requirements |
802.3at Power over Ethernet Plus (PoE+), Cisco Universal PoE (Cisco UPOE®)
Cisco power injector, AIR-PWRINJ6=
802.3af PoE
Cisco power injector, AIR-PWRINJ5= (Note: This injector supports only 802.3af)
|
Environmental |
Cisco Catalyst 9105AXI
Nonoperating (storage) temperature: -22° to 158°F (-30° to 70°C)
Nonoperating (storage) altitude test: 25˚C, 15,000 ft (4600 m)
Operating temperature: 32° to 122°F (0° to 50°C)
Operating humidity: 10% to 90% (noncondensing)
Operating altitude test: 40˚C, 9843 ft.(3000 m) Note: When the ambient operating temperature exceeds 40°C, the access point will shift from 2x2 to 1x1 on the 2.4 GHz radio.
|
Available transmitpower settings (Max/Min) |
2.4 GHz ◦ 20 dBm (100 mW) ◦ -7 dBm (0.2 mW)
|
5 GHz ◦ 20 dBm (100 mW) ◦ -7 dBm (0.2 mW)
|